Capturing the prototype paranid perseus
Moderator: Moderators for English X Forum
-
- Posts: 95
- Joined: Sat, 5. Apr 03, 18:57
Capturing the prototype paranid perseus
IS it possible to capture the prototype with its 125mw sheilds intact or will you always end up with three slots for 25mw sheilds?
-
- Moderator (Nederlands)
- Posts: 2967
- Joined: Wed, 6. Nov 02, 20:31
-
- Posts: 1478
- Joined: Wed, 6. Nov 02, 20:31
Re: Capturing the prototype paranid perseus
The Perseus mission is programmed to lose the 125MW shields after capturing it. But you still get a ship with 3x25MW shield bays, which is still better than a poke in the eyenagant wrote:IS it possible to capture the prototype with its 125mw sheilds intact or will you always end up with three slots for 25mw sheilds?

Cheers
-
- Posts: 1505
- Joined: Tue, 14. Jan 03, 22:03
I have managed to get the 125MW shields off the Perseus. Here's how I did it.

Spoiler
Show
Whilst capturing the Perseus, I,ve found a way to get hold of the 125MW shields off the ship. As an experiment, I was reloading from a save game to try and get the Perseus with the jump drive and lasers intact on capture. On a couple of occasions on capture, I noticed that the shields on the Perseus started to regenerate (a bit like other ships do, but for a longer period). I checked the information of the Perseus during this period of time and the 2 x 125MW shields were still listed. When the Paranids hailed me to congratulate me, the shields disappeared and I ended up with three empty shield slots that would take a total of 75MW max (as per normal). What I did was to use the freight beamer to transfer the 125MW shields from the Perseus to the X shuttle before the Paranids hailed me. A nice little earner (2 x 1.7 Million credits) if you sell them. Used them in a new carrier. Pity I can't reinstall them back in the Perseus though.
