I've recently dusted off X3 again and I must say the new updates and bonus pack make it like a whole new game
I'm having problems with the CLS however. I ran CLS1 ok but the CLS2 isn't working as expected.
As a CLS1 he was delivering Ecells from one complex and distributing them to several. I wanted him to move around some other wares during his trips so I changed him to CLS2.
At step 1 he would load up the specified number of ecells and start his route but when he reached the first fab at step 2, he would unload ALL of his ecells, or as many as the fab could accept. The 0 0 0 feedback clearly stated that he should only unload 800 ecells.
I tried stopping and restarting him several times, deleted the istructions and re-added them, etc. but I could not fix this behavior. I finally gave up and put him back on CLS1.
I later started another CLS2 and had him move silicon and crystals around and he worked fine. I had him picking up and dropping off complete loads from one complex to another, so I'm not sure if he would have the same problem.
But he does have a different problem. He has leveled up to the point where he should be using his jump drive but he doesn't. He has all required equipment, ecells, both scanners, and no goggles but he still wont jump.
Any ideas?